Myco Arm Extender | Instructions

Step 1

Note the position of the clamps and screws so that they can be reassembled in the same way.

Step 2

Undo the screws on the arm extender and release the clamps.

Step 3

Attach the arm extender onto the Swivel Bather as shown in the above diagram.

Step 4

Insert the screws from the inside of the clamps so that they protrude on the outside. This is an important safety consideration. Loosely assemble all nuts

Step 5

Slide the arm extender forwards until the back of the arm extender is up against the seat back.

Step 6

Fully tighten the top two nuts of each clamp and then the bottom nuts. The screw ends must protrude through the nuts.

Step 7

With the Swivel Bather correctly assembled over the bath (as per Swivel Bather instructions), carefully apply downward pressure to the front of the arm extender to ensure that the unit is safely installed.